How To Install Laminate Flooring

Undertaking to Learn How to Install Laminate Flooring

There are a thousand and one different benefits that come from laminate flooring. However, you will need to learn how to install laminate flooring to be able to make the most out of these advantages. Thankfully, it is not too hard to install this kind of flooring, so you can be certain that you will have a relatively easy, and hopefully fun, time doing the installation on your own.

Basically, laminate flooring is very easy when it comes to its installation. It will also stand up to any wear or tear and ranks among the cheapest flooring options available. You also do not have to remove your current floor apart from the carpeting. Also, no special preparation is needed before you install the floor.
However, before you start installing the laminate, some things have to be done. As a start, you will want to procure the foam underlayment and the laminate floorboard. The underlayment will cushion your flooring for a dampening sound and resilience.
To decide how much foam underlayment and laminate you need to purchase, just multiply the width and length of your room. This will give you the required square footage. Every box with laminate has a label informing you the square feet to be covered.

Ensure you have bought 20 percent extra of these products than you need. In case you make many mistakes or miscalculation, this extra flooring will save you. You will have to use carbide tipped blades or a hand saw to trim the laminate pieces. You will want to cut right into the flooring’s good side so that in case of any splintering or tear out, it will not mark your board’s face.

Learning how to install laminate flooring will also teach you that most laminates do not require glue. This is because they come with interlocking grooves and tongues. In case you fear that dampness or water will seep through such as in the kitchen, entryway or mudroom, run light beads of wood glue that is water proof along every tongue before you mate it down with the groove.



There are a number of things you will need as you install the laminate flooring. The first is the laminate and the foam under- layment which is normally sold in terms of rolls which range from 36 up to 42 inches in width.
You will also need a six mill sheeting of plastic if you will need to install over concrete. These are also sold in 10- feet wide rolls. Duct tape, rubber mallets, thresholds, and installation kits with spacers, tapping block and pull bars will also be required.

Finally, every guide on how to install laminate flooring will inform you that you will need a hand saw or blade that is carbide tipped and installed onto some power saw and flush cut saw to help you in undercutting door jambs will also be required. Knee pads will give you greater comfort and water proof glue is optional unless you are looking to install in areas that have a likelihood of getting wet.